Gear oils CLP / Oils / Catalog / Belwax

Gear oils are intended for use in gear transmissions of modern imported industrial equipment requiring the use of high-quality alloyed oils with increased anti-wear, lubricating, extreme pressure and anti-corrosion properties. Oils can be used in the circulation systems of various mechanisms operating under increased loads, in friction units of automatic hot stamping presses and other heavily loaded units of industrial equipment. Depending on the viscosity and component composition, four grades of oil are produced: ZGV CLP-150, ZGV CLP-220, ZGV CLP-320, ZGV CLP-460. The product meets the requirements of the Technical Regulations of the Customs Union TR CU 030/2012 "On requirements for lubricants, oils and special liquids". Packaging options: bulk, 180 kg barrel.

Characteristic	Norm

Density at 20°C, g/cm³, not more than	0.960
Kinematic viscosity 40°C, mm²/s	135-165 (CLP 150), 198-242 (CLP 220), 288-352 (CLP 320), 414-506 (CLP 460)
Viscosity index, not less than	90
Pour point, °C, not higher than	minus 24 (CLP 460 - minus 15)
Flash point, determined in an open crucible, °C, not lower than (according to TRTS 030/2012 - not lower than 135)	230
Acid number, mg KOH/g, not more than	1.6
Mass fraction of water, %, not more than	0.1
Content of mechanical impurities, % (according to TRTS 030/2012 - 0.03)	none
Ash content, %, no more than	0.35
Tribological characteristics on ChMSh at (20±5)°C:
welding load (Рс), N, no less than	250
wear index, mm, no more than	0.31 (CLP 460 - 0.32)
Corrosion tests:
on steel plates	Passes
on copper plates, points, no more than	1 in
Changes in weight of UIM-1 rubber after exposure to oil for 72 hours at 125°C, %, no more than	+5.0